• Categories:Industry News
• Author:
• Origin:
• Time of issue:2018-01-31
• Views:12

(Summary description)
　　High-voltage vacuum circuit breakers play this very important role in the power grid. Different circuit breakers have different wiring methods. Common high-voltage vacuum circuit breakers used in power grids have the following three common wiring methods. Let's take a look with me below.

　　There are three main wiring methods for high-voltage vacuum circuit breakers, which are widely used in other industries such as electronics. What kind of device is it? The editor pointed out that it converts the state of some electrical equipment and lines to overhaul state. The editor pointed out that the three most commonly used wiring methods are our

　　It should be understood that they are the insert type behind the front plate and the drawer type. How to access it specifically? Let's follow the editor to understand it.

　　Rear panel access, it has a notable feature, that is, it can be replaced or repaired, which is also an advantage. You don't need to wire it again, which saves a lot of things. However, because of the particularity of the product and the particularity of the structure, the mounting plate and mounting screws are installed according to the requirements when leaving the factory.

　　These are all dedicated and have requirements for configuration. We should be clear that whether the large-capacity devices are reliable or not is related to the normal use of the circuit breaker. Therefore, we need to pay attention to it before installation. The factory's requirements need to comply with it If it is done, it must not be mistaken. It must be installed in accordance with the needs and instructions of the manufacturer, so that it will be safer to use.

　　Let’s look at the plug-in access again. First put the mounting seat in. The upper connecting board has six sockets, and the back of the connecting board or the mounting seat has a bolt mounting seat. When in use, just put the high-voltage vacuum circuit breaker directly on the mounting seat. What should I do if the device is damaged?

　　What about 　　? The method is actually very simple, as long as you pull out the bad and replace it with the good one, or replace the old one with the new one, it is more convenient to replace, and the time is short, which is the hobby choice of the users.

　　There is also the last commonly used drawer type access, which is counterclockwise when entering and exiting the drawer, or in other words, the rocker is clockwise, and there is a secondary circuit on the main circuit. The plug-in structure is used, and the isolator has The omitted, secondary use method seems to be very economical. not only,

　　It provides great convenience for operation and maintenance, high safety, and reliability.

　　After reading the three wiring methods, I believe you can understand them through the detailed introduction above. These are more commonly used, plug-in access, back-board access, and drawer access. Therefore, it is necessary to master their skills. But it needs to be clear that theory and practice are different, and in actual operation

　　is often more difficult, there are more places to pay attention to, and you may encounter other problems and fall into some misunderstandings. You still need to pay more attention to practice, and practice makes perfect and avoids mistakes.